I use both the fanaleds and the siminstruments software.
I want do permanently disable the output for the siminstruments dash via the fanaleds software - I can successfully do so under the hardware page in fanaleds. (Clicking the checkboxes: disable clock and disable data output)
However my changes are not saved upon restart of the software or when another hardware is connected to the PC.
So whenever I restart the fanaleds software the changes are set to default. Or when I start the CSWB the settings for the SimInstruments Dash are set to default.
I can run both software simultaneously when deactivating the device under the hardware settings in the fanaleds software.
Is there a way to save my changes? Or can I somehow ignore the SimInstruments Dash in the fanaleds software?
Or is this simply a little bug?
Changes for the CSW saves automatically.
Fanaleds software is the latest - 2.2e
Siminstruments is the latest 1.2.21 and the dash is at the latest firmware 1.6
Thanks for this great piece of software and regards
Sebastian