Hi I've just received my V3 pedals and have the same issue.
My log file data is as follows:
0: Log opened with debug level: 4
0: Log opened with debug level: 4
2: Setting up hardware
2: Beginning device enumeration
2: Error reading serial
2: Hardware found on ID: 0 name: ClubSportPedal vendor: FANATEC ver: 0.1 ser: RAWID-0eb7-183b
2: Error reading manufacturer
2: Error reading serial
2: Hardware found on ID: 1 name: G27 Racing Wheel vendor: ver: 12.38 ser: RAWID-046d-c29b
3: Found device match in config from serial: G27
2: Finished enumeration devices
2: Showing init routine
2: Hardware ready to go
0: Log opened with debug level: 4
0: Log opened with debug level: 6
2: Setting up hardware
2: Beginning device enumeration
6: \\?\hid#wmvirtualdevice#2&25d493e&2&0000#{4d1e55b2-f16f-11cf-88cb-001111000030}
6: \\?\hid#vid_0eb7&pid_183b#7&243cae68&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030}
2: Error reading serial
2: Hardware found on ID: 0 name: ClubSportPedal vendor: FANATEC ver: 0.1 ser: RAWID-0eb7-183b
6: \\?\hid#vid_0458&pid_003a#7&731272c&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030}
6: \\?\hid#vid_046d&pid_c29b#7&3a5fc58c&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030}
2: Error reading manufacturer
2: Error reading serial
2: Hardware found on ID: 1 name: G27 Racing Wheel vendor: ver: 12.38 ser: RAWID-046d-c29b
3: Found device match in config from serial: G27
6: \\?\hid#wmvirtualdevice#2&2b3e62a0&2&0000#{4d1e55b2-f16f-11cf-88cb-001111000030}
6: \\?\hid#vid_03f0&pid_0024#7&141529c3&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030}
2: Finished enumeration devices
2: Showing init routine
2: Hardware ready to go
5: Setting up GUI
5: Setting up notificationIcon
6: Running on DPI: 0
6: Form created with points: Left-75 Right-471 Top-81 Bottom-573
6: joystick G27 Racing Wheel:RAWID-046d-c29b => button 137 => value 128
Dirk has been working on the CSP V3 support, and I've emailed a few people to test out the new version. If everything is working like it should we will release the new version soon. Thanks for your patience.