Problems with Fanatec CSL Elite and RevLights
Posted: 15 Jan 2019, 18:34
Hi there,
that’s my first post here and first I’d like to say hello to all.
Second:
I’m using fanaleds first time and have the following problem. After installing I used the “fanaleds interface” to setup my wheel (Fanatec CSL Elite in PC-Mode). The three digits in the wheel work ingame (PC2) as set in fanaleds software. I set Velocity and gear. Perfect!
I also set the leds in the wheelbase. I disabled rpm in the ingame options. Result: when setting in the fanaleds software each led is on when selected. After closing the fanaleds software and driving no led is going on.
If I enable ingame options the rpm the leds are working, but not as programmed.
Does anyone have an idea, where I’m wrong?
Thanks in advance
Harry
that’s my first post here and first I’d like to say hello to all.
Second:
I’m using fanaleds first time and have the following problem. After installing I used the “fanaleds interface” to setup my wheel (Fanatec CSL Elite in PC-Mode). The three digits in the wheel work ingame (PC2) as set in fanaleds software. I set Velocity and gear. Perfect!
I also set the leds in the wheelbase. I disabled rpm in the ingame options. Result: when setting in the fanaleds software each led is on when selected. After closing the fanaleds software and driving no led is going on.
If I enable ingame options the rpm the leds are working, but not as programmed.
Does anyone have an idea, where I’m wrong?
Thanks in advance
Harry