Fanaleds forum

System is Windows 7 (64bit) running Rfactor 2 (64 bit)

I've not been able to get Fanaleds working properly with Rfactor 2 since it all went 64 bit.

Have completely uninstalled & retried to no avail. Shift lights work fine as does gear indicator left display shows speed ok but does not count laps or show race position. Right display either just flickers numbers or is just blank.

Have 12 position dials on either side and have reassigned but still not working. Friend with same systems is also having the same problems. Seems to have started when it all went to 64 bit.

Is this a known issue? Is there any fixes?

thanks

JR

Solved the first problem of lack of total operation of my sli pro, now I have this problem.
I confirm all above reported by Jonrarit.
Someone can control?
Thank You!!

Make sure you use the 64-bit plugin.

Still have this issue on my system and yes I have the 64 bit plugin

please advise

I confirm: when in doubt, I put the plugin in both folder bin32 (FanaLEDsPlugin.dll) and 64bin (FanaLEDsPlugin_x64.dll)

Did everyone also check this: http://www.fanaleds.com/forum/viewtopic ... =570#p2545 ?

Bose321 wrote:Did everyone also check this: http://www.fanaleds.com/forum/viewtopic ... =570#p2545 ?

?

yes I checked that topic too and made sure all was correct in the json file. It still leads back to this thread though and the 2.2h software not collecting the timing and position data from rfactor 2

Back to you guys at Fanaleds again......

jr

Which build are you on? We have verified together with ISI that it works fine on the x64 version of build 906. I can't think of anything right now when you have loaded the correct plugin and are running build 906... Maybe that Dirk can think of something.

I'm running build 910 (just released) Clean install but have had this issue ever since it all went 64 bit....as have quite a few others by the look of things

jr